Gtechniq Crystal Serum Light + Exov4 Ceramic Coating Kit (30ml/50ml) 5 Year Durability

GTECHNIQ CRYSTAL SERUM LIGHT + EXOv4 CERAMIC COATING KIT

Looking to ceramic coat your car but not sure where to start?   Our 'Gtechniq Crystal Serum Light + Exov4 Ceramic Coating Kit' is everything you need to prep and coat your vehicle.  We'll even guide you through the process with detailed instructions (see below). 

KIT CONTENTS:
🔹1 x Gtechniq Crystal Serum Light Ceramic Coating (30ml/50ml)
🔹1 x Gtechniq Exov4 Hydrophobic Coating (30ml/50ml)
🔹1 x Microfibre Coating Applicator
🔹1 x Plush Paint Cloth
🔹12 x Yellow 'Coating Take Off' Microfibres
🔹1 x Prep Spray (500ml)

INSTRUCTIONS:

CRYSTAL SERUM LIGHT

• To apply Crystal Serum Light make sure your vehicle is indoors and can stay indoors for 12 hours after application, do not apply in direct sunlight
• Only apply the product at a temperature between 10°c and 25°c
• Shake well and wear gloves
• Wash and decontaminate your paintwork thoroughly prior to application. If required, polish your paintwork, either by machine or hand, to remove any imperfections
• Spray Prep Spray into a Plush Paint Cloth and wipe down each panel in small sections
• Soak the Microfibre Coating Applicator with 3 full measures of CSL from the pipette and work the liquid into the pad to get an even saturation
• Replace the lid on the bottle and set aside – do not keep the bottle in your hand as this promotes premature curing
• Apply in overlapping strokes to an area roughly 2ft by 2ft, or work to the bodylines of the vehicle
• Immediately remove residue with a Yellow 'Coating Take Off' Microfibre – you may need to buff the same area several times, but avoid doing it with too much force. We recommend the use of 2 cloths at any one time. Make sure the cloths are rotated during residue removal to prevent CSL curing in the cloth- this can make buffing residue difficult
• Inspect the surface for residue with a bright, diffused light source
• If you remove residue and it cures fully you should polish the area and reapply CSL
• Throw away Yellow 'Coating Take Off' Microfibre after coating removal
• Wait approximately 2 hours after applying CSL to apply Gtechniq Exo (if desired)
• Store in a cool, dry place
• Use within 3 months of opening
  
  

EXO V4 HYDROPHOBIC LAYER

• EXOv4 can be applied as a standalone sealant or as a top layer for Gtechniq C1 Crystal Lacquer or Gtechniq Crystal Serum Light (CSL) - we recommend applying C1 or CSL as a base coat for easy to mark and dark paints
• If you are applying over C1, EXOv4 should be applied a minimum of 4 hours, but less than 12 hours, after you finish the C1 application
• If you are applying over CSL, EXOv4 can either be applied straight away starting the process at the same place you did with CSL. For best results wait two hours before applying to let the product flash-off longer
• Ensure that your vehicle is out of direct sunlight but warmer than 5 degrees celsius, is completely dry and will stay dry for at least 12 hours after application
• Wipe down all surfaces using Prep Wipe and the Plush Paint Cloth (apply the Prep Spray to the cloth and buff - not directly to the panel) – if you are applying over newly applied C1 or CSL, this step is not required
• Shake the bottle well and wear gloves
• Prime the Microfibre Coating Applicator evenly with a good amount of product so that the pad is damp
• Apply with applicator provided in overlapping strokes to a small panel or half a large panel. Wait 1 to 2 minutes after applying to a panel and buff with a Yellow 'Coating Take Off' Microfibre followed by a second Yellow 'Coating Take Off' Microfibre to remove any smearing, leaving the surface slick
• Once you have finished coating your vehicle we recommend repeating the process starting from the same place as you did for the first layer and coating panels in the same order so that you coat your entire vehicle with two layers of EXO
• Allow the coating to cure for at least 12 hours before getting wet
• After application we recommend that you do not wash the car for at least a week
• Store in a cool, dry place
• Use within 3 months of opening